Handheld scanner test

掃描器測試 · about 10 minutes

Which device? 哪部機？

Nothing appears when you scan? 掃描後沒有反應？

Open the Urovo Scanner settings (Settings → Scanner, or the "Scanner" / "ScanWedge" app). Look for:

  • Output mode: choose Keyboard / Keyboard emulation / Input method (not "Broadcast" / "Intent").
  • Suffix / Terminator: Enter (or "CR" / "LF").

Write down what it was set to before you change it, then check the Zkong label app still scans (check 9).

Checks 檢查

1. Scans appear on the page
Scan any product.
waiting
2. Each scan ends by itself (Enter)
Shown automatically from your scans.
waiting
3. 10 quick scans, all counted
Scan the same item 10 times as fast as you can. Count should go up by exactly 10, no joined-up codes.
waiting
4. Case barcode reads in full
Scan an outer-case barcode (usually 14 digits). Leading zeros must stay.
waiting
5. No on-screen keyboard pops up
While scanning, does the keyboard cover the screen?
waiting
6. Page beeps / buzzes on each scan
Turn the volume up.
waiting
7. Take a photo
For unknown products later.
Photo taken
waiting
8. Scans survive a reload, and Wi-Fi off
Tap Reload once with Wi-Fi on. Then turn Wi-Fi off, scan 2 items, tap Reload again. The page must come back with the count unchanged. Then Wi-Fi back on.
waiting
9. Zkong label app still scans
Close this page, open the Zkong app, scan a shelf label, come back.
waiting

Send the result 傳送結果

Show report

    
All scans
      
#CodeLenHow